The Duchy - Lord Tiernan

A DOUBLE Ball Gag

   This is a rare bondage prop, but can be a LOT of fun with the right players. ; )
   For this one you need two rubber balls, two dog collars and a dowel screw. The ball should be 1.75" on average, but can be 2-2.25" for large mouths. You can often find these at SuperPetz or other pet supply place. The collar should be 20-22" long, but be sure that you get one with only one thickness down the length. Some nylon ones over 20" have a double thickness and you don't want that. You will need to bend the collar in half the long ways and this is impossible with the double thick... You can get the dowel screw at a good hardware store. It needs to about 1/2" longer than the diameter of one of the balls that you selected.
   Tools: I used a drill press, as I happen to have one, but a regular drill will work OK. You will also need a drill bit about 3/4 the wide of your dog collar, a vice and probably a needle-nose pliers.

1. Here are the materials I used.	2. You will need 2 different drill bits. One bit needs to be a little less than 3/4 the width of the collar and the other bit about 1/2 as thick as the dowel screw.	3. Use the large bit to drill through the balls just as you would for the regular ball gag. You will need a vice and a drill. I am using a drill press, because I have one, but you don't need one.

4. Now you need to make the whole for the dowel screw.	5. Note that you need to chose where you are going to put the hole. As shown below, I am selecting to have the logos aligned and visible...	6. Mark where you want the hole to be.

7. Now it is important that you do not drill all the way through the ball this time	8. In this case I needed to have the hole 1.25 inches deep, so I mark my drill bit so I know when to stop drilling.	9. Position the ball for drilling

10. Drill down to your mark	11. Repeat for the other ball	12. Thread the collar through the balls just as you would for the regular ball gag. You now have 2 ball gags with little hole on the front side.

13. Use a pair of pliers to screw the dowel screw to the first ball.	14. Then screw the first ball into the second	15. Making the balls meet in the middle.

16. A variation on this is to leave a little of the post showing so there is a little more space between your subs' noses. : ) If you want to do this you will need to get a dowel screw that is a little longer...