口塞
一个用绳子做的位子口令(想想小马玩位子)!如果你用1/4″(6mm)的绳子做一个，大多数人都可以处理它，但如果你用更大直径的绳子(3/8″(8mm)或更多)，这个插科打诨可以是非常具有挑战性的人嘴。.美好的时光....
对于这条领带，我使用了一块15英尺（约5米）的6毫米大麻（自然色），由我的附属公司Twisted Monk>提供。
我使用的是由我的附属机构天然麻绳提供的惊人的Twisted Monk。 看看他们吧!
9评论。
发表 评论
要发表评论，您必须先登录。
Do you know a good way to ensure that that the bit ends up in the center of the rope? I would like the left over tail to be even lengths so I can use it for other purposes
Unfortunately, this is just a trail-and-error kind of thing. Although you can tie the knot, but not tighten it too much at first, then work the rope through in one direction or the other to get it centered after the fact.
How much diameter would you/did you use for the core?
I used a quarter inch (~6mm) for mine. You could use bigger if you want to force the jaws further apart… Work it out with your partner 😉
Can this be done without the core, and just a loop on each end? If so I would like that as a more flexible bit/gag. Thanks!
Yep! It can be done that way, too. you just have to make the wraps very tight. However, if you do it that way, it is very flexible and can almost always be spit out.
Oh, sure! I only use the core to keep it a little more stiff so that it’s harder to spit out and offers more control. If you prefer the softer version, it’s totally fine to do this without the core. You do however need to wrap it quite tight to keep it firm and help it keep its shape
What are you using for a core on this, and where do I find one? 😁
I used a piece of aluminum rod in which I carved a few grooves using a round file and a drill. I stuck a length of rod into the drill chuck then ran the drill and put the round file against the spinning rod to carve the grooves. 🙂