Skip to main content
TheDuchy

Teardrop Bolero

By Lazarus Redmayne

Easy

The Teardrop Bolero is an adorable shrug I developed while creating the Adapting Ties tutorial. I needed something that would allow certain adaptations to be easily seen. This is a simple, attractive upper chest harnessChest HarnessA type of harness that focuses on the chest area, providing both aesthetic appeal and structural support for suspensions. that can be used simply as a fashion piece (this would nicely complement any of the Woven Hip Harnesses, the Teardrop Hip Harness, or the Leto Hip Harness if going for a fashion statement) or as a base layer of bondage that would allow you to connect additional layers to it. For example:

  • You can put a single column on each wrist and then attach each to the back of this chest harness individually, allowing you to individually adjust the position of each wrist in a behind-the-back tie.
  • You could use this to anchor the ankles into hogtieHogtieA restrictive tie in which the wrists and ankles are bound and then drawn together behind the body, typically leaving the bottom face-down and largely immobilized. It creates a strong sense of helplessness but can compress the chest and belly against the ground. Because that pressure can make breathing harder, it warrants close attention to the bottom's airway and quick, easy access to release., instead of the connecting them to your partner’s wrists.
  • You could use this harnessHarnessA structural rope pattern designed to distribute weight and provide support, often used in suspension work.Bulldog Harness - X BackHeavy Elbow HarnessLeto Hip HarnessPentagram Harness v2Star Harness with ArmsShinjuUnchastity Belt as the connection point for an EbiEbiA predicament tie that folds the body forward, curving the back so the chest is drawn down toward crossed or bound legs. Its name means shrimp (海老), after the curled shape it produces. Because it concentrates strain the longer it is held, it calls for close attention to the bottom's breathing, circulation, and comfort.
  • … among many other uses…

Blog Connection! When shooting this tutorial, I ended up doing a modification that I don't discuss below. To see a different way of doing the front, check out Blog: Comparison is the Thief of Joy, about halfway down, under sub-heading "Another example".

Risk Management and Safety

Do Not Use For Suspension!

This harness should not be used for suspensions; there is nothing truly anchoring it down, preventing it from working its way up over the shoulders.

Rope Needed

For this tutorial, I used one 30' (~9m) piece of red 8mm (5/16") MFP, provided by my affiliate AgreeableAgony.com. Extend your rope if you need more; use it up if you have too much.

MFP is great stuff! It is soft, strong, waterproof and machine washable. The colors don’t bleed or fade. If you are in the market for colored rope, check out AgAg! If you use this link, it will give you 5% off orders over $35. Also, check out their IG for more inspiration.

Examples

Video

Video Contents:

  • Core Technique - 0:16
  • Alternate Front - 5:20

Detailed Step-by-Step Version (For those new to rope)

Start with the bightBightA curved section in the middle of a rope where the line doubles back on itself to form a U, without the two parts crossing over each other. Folding a rope in half creates a bight at its midpoint, which is the starting point for a great many ties. at your partner’s back.

Run the tail around your partner’s upper chest, above the breasts / across the mid pectorals.

Bring the tail to the back and run it through the bight to complete the Lark’s HeadLark's headA basic hitch made by folding the rope into a bight, passing it around an object, and drawing the ends back through the loop. Also known as the cow hitch, it is a fast way to attach rope to a ring, bar, or another line, though on its own it can shift or collapse under uneven load.Lark's Head Knot.

Reverse tension and…

… wrap around your partner’s body…

… twice more, placing those wraps below the first.

Run the tail through the secondary bight…

… then continue following the natural curve of the rope and run the tail over the shoulder…

… to the front.

Run the tail to the center of the chest and weave it into the strands: Over the top two strands, under the middle two strands, and over the lower two strands.

Reverse tension and continue weaving, under-over-under.

Run the tail over the other shoulder to the back.

Take a moment to position the straps to provide a gap between them and the neck. The second shoulder strap will run here.

Bring the tail to the opposite side, running it under the outgoing shoulder strap…

… then run the tail over the strands of the primary bight, under the middle two strands, and over the lower two strands.

Reverse the tension and run the tail back up the other side, this time going under-over-under.

(Optional) For a more teardrop appearance, keep the strand running in parallel like railroad tracks.

Run the tail under the shoulder first wrap of the strap…

…then on to the opposite shoulder.

Run the tail over the shoulder to the front, then to the opposite side and weave it into the pattern. Go over the shoulder strap, then…

… under-over-under the chest strap.

Reverse tension, again keeping the strands in order like railroad tracks, and…

… weave it into the pattern as you go to opposite shoulder, over-under-over.

Weave it under-over through the shoulder straps, then…

… continue over the opposite shoulder.

Take a moment to make sure that the strands of this second shoulder strap have the same tension as the first set of strands. (Check & adjust both sides.)

Weaving the tail into the pattern. Under-over the shoulder straps, then…

… under-over-under the chest straps.

The harness itself is now done. Use up the remaining rope and lock it off. Here are several options:

If you only have a little rope left, you can lock off with a Half HitchHitchA knot that fastens rope to another object such as a limb, a bar, or another line, and relies on that object to keep its shape. Remove what it is tied around and a hitch generally falls apart, which is what distinguishes it from a knot tied in the rope itself. It is the parent category for a range of rope-bondage ties, including the half hitch.Anchor Hitch & RTTHHHalf-Hitches and then tuck the end under the weave.

In this case, I have enough rope to …

… continue the weaving pattern up the other side.

At this point I could just tuck the end under the weave, then…

… tighten the weave…

… completing the harness looking like this.

Or I can continue across the top of the central weave…

… weaving the tail through the shoulder strap lines, then…

… tucking the end under the weave

Done!


To see a different way of doing the front, check out Blog: Comparison is the Thief of Joy, about halfway down, under sub-heading "Another example".

Highlights Version (Far less detail. For people with experience)

Start with the bight at your partner’s back. Run the tail around your partner’s upper chest, above the breasts / across the mid pectorals. Bring the tail to the back and run it through the bight to complete the Lark’s Head.

Reverse tension and wrap around your partner’s body twice more, placing those wraps below the first.

Run the tail through the secondary bight, then continue following the natural curve of the rope and run the tail over the shoulder to the front.

Run the tail to the center of the chest and weave it into the strands: Over the top two strands, under the middle two strands, and over the lower two strands.

Reverse tension and continue weaving, under-over-under. Run the tail over the other shoulder to the back.

Take a moment to position the straps to provide a gap between them and the neck. The second shoulder strap will run here.

Bring the tail to the opposite side, run it under the outgoing shoulder strap, then run the tail over the strands of the primary bight, under the middle two strands, and over the lower two strands.

Reverse the tension and run the tail back up the other side, this time going under-over-under.

Run the tail under the shoulder first wrap of the strap on its way to the opposite shoulder.

Run the tail over the shoulder to the front, then to the opposite side and weave it into the pattern. (Over the shoulder strap, then under-over-under the chest strap.)

Reverse tension (this time keeping the strands in order like railroad tracks) and weave it into the pattern as you go to opposite shoulder.

Take a moment to make sure that the strands of this second shoulder strap have the same tension as the first set of strands. (Check & adjust both sides.)

Bring the tail over the shoulder to the back, weaving it into the pattern as you go.

…

The harness it self is now done. Use up the remaining rope and lock it off.

In this case, I have enough rope to continue the weaving pattern up the other side and then across the top of the weave, through the shoulder strap lines.

Tuck the end under the weave.

Done!


To see a different way of doing the front, check out Blog: Comparison is the Thief of Joy, about halfway down, under sub-heading "Another example".

Artist's Corner